I Too Now Have a Trailer Project

[Ironheadziggy76]

PourUB welcome to the site, the trailer looks great!

[PoorUB]

Originally Posted by G wizz

PourUB,
That's a cool setup ya got there. What did you use for a rear axle & bearings, and what kind of wheel do you have on it?

G wizz

The wheel came frm a Yamaha YSR50. Actually a front wheel. The tire is rated for 95 MPH and ~600 pounds so it is more than adaquate for the job. The axle itself seems a bit wimpy, 10 MM is all but I figured if it was good enough to support the motorcyle and rider, it will be fine on my trailer. The trailer weighs in at 75 pounds, not sure of the tongue weight, I should check some time.

[Timmer]

PoorUB:

Do you have any photos (or links to photos) you can share of the fabrication of the trailer? Many of us are on the lookout for ideas and techniques.

Timmer

Originally Posted by PoorUB

I just popped in here from another group that referanced this thead. Great job on the trailer! I do a little fabricating to, but I am a total hack in comparison of your skills!
Not to high jack your thread, but I built a trailer mysself this spring, the second one with simular frame constuction as the first, but a differant cargo box this time.

<remainder snipped>

[PoorUB]

Originally Posted by Timmer

PoorUB:

Do you have any photos (or links to photos) you can share of the fabrication of the trailer? Many of us are on the lookout for ideas and techniques.

Timmer

I will start a new thread and let this one go back to the OP.