Unigo hitch adaptor for ball mount

[motomac]

I no longer have my Unigo trailer and hitch, but still have the adaptor from the Ungio hitch. The Wing I bought second hand had a hitch, but not the thingy that went into the receiver. since I had bought the Unigo adaptor for a receiver hitchas well as having an adaptor made for a ball mount trailer, I didn't sell either with the Unigo. Here is what the adaptor looks like. It is just a piece of 2 1/2" steel, bent at a 90 degeree angle with 5 holes drilled into it. The long end is 8" on the inside of the bend and the short side is 4" to the inside of the bend. For those of you that have a Unigo hitch, this is what you need to pull a ball hitch trailer with the hitch. If you get the adaptor Unigo sells, it will place the ball on the trailer about 4" too high for safe towing.

[ImRubicon]

Thanks Mac
I printed these out .
Now I just need to find a shop close by work .
Its a good day for a ride

[jdaniels]

I also used the "UNIGO" trailer hitch on the ST and they wanted too much for the adapter to mount the ball on so I made one from a piece of scrap I had laying around.I cut the shank off the ball and welded it onto the piece of steel I'd bent and drilled to match the unigo holes.I coated it with "RED HAND" to fight rust.Works good so far.We've towed the "PiggyBacker XL" trailer about 4k miles with this setup.:)